MS & SS Fabrication
Gates, grills, stainless steel work, structural fabrication and roofing sheds — cut, welded and finished to the measurements taken at your site.
Engineering & Metal Fabrication
Most fabrication work fails for one reason: it was made to a standard size and forced to fit. We measure the opening first, agree the section and thickness with you, and fabricate to those figures.
That covers everything from a single window grill to a full compound gate, a stainless steel handrail or the structural frame and roofing for a shed — for homes, shops, offices and industrial sites.
See completed work
Types of Work
Each of these is handled in-house, so a job that needs more than one trade still runs to a single schedule.
01 / Gates
Main gates, side gates and sliding gates in mild steel, fabricated to the width and height of your compound wall and finished with primer and enamel or PU paint.
02 / Grills
Window grills, balcony grills and safety grills fabricated from MS square tube, flat and round bar — plain or with a decorative pattern to suit the elevation.
03 / Stainless Steel
Stainless steel work where finish and corrosion resistance matter — handrails, railings, gates and frames in SS 202, 304 or 316 with a mirror or hairline finish.
04 / General & Structural
General and structural fabrication — beams, columns, frames, platforms, ladders and one-off jobs made from a drawing, a sketch or a sample.
05 / Roofing
Sheds, car parks, terrace roofing and factory roofing — structural frame, purlins and sheeting, set out to the span and slope your site needs.
Materials & Specifications
Typical options — the exact section and thickness are fixed once the site measurement and load are confirmed.
| MS sections | Square tube 20×20 to 50×50 mm, rectangular tube, angle, channel, flat and round bar |
|---|---|
| MS sheet | 1 mm to 3 mm plain sheet; perforated and designer sheet for gate infill |
| Stainless steel | SS 202 / 304 / 316 — pipe 25 mm to 50 mm, sheet 0.8 mm to 1.5 mm, mirror or hairline finish |
| Structural steel | I-beam, H-beam, C and Z purlin, tube trusses — sized to span and load |
| Roof sheeting | GI and colour-coated profile sheet 0.45 mm to 0.50 mm, polycarbonate skylight |
| Finishing | Surface cleaning, red-oxide or zinc primer, enamel or PU top coat; powder coating on request |
| Joining | MIG and arc welding, ground and finished at joints; bolted connections where required |
| Hardware | Gate rollers, hinges, latches, locks and stoppers to suit gate weight and span |
Working from a drawing? Send the PDF or a photo of the sketch on WhatsApp and we will confirm feasibility and quantity.
Benefits
01
Fabricated to the measured opening, so gaps, packing pieces and on-site cutting are avoided.
02
Section and thickness chosen for the span and use, not the cheapest tube that will pass.
03
Cleaned, primed and painted properly, which is what decides how a gate looks after three monsoons.
04
Gate, grill, railing and shed work run together instead of waiting on separate contractors.
Project Gallery
Gates, structural steel and workshop work from recent AV FAB.TECH projects.
Why AV FAB.TECH
Every gate, window and mesh panel is fabricated to the dimensions taken at your site — not cut down from a standard size.
We advise the section, thickness and finish that suits your opening, budget and exposure, and confirm it before work starts.
Fitting, alignment and finishing are handled by our own team, so the work is left square, level and ready to use.
Fabrication, uPVC and mesh work are all handled in-house — you deal with one team from measurement to handover.
Get in Touch
Share your measurements, a drawing or a photo of the opening and we will confirm the material, design and quotation.
WhatsApp Us
